SECTIONAL GARAGE DOORS

Sectional garage gates have the highest functional standard. Models are available in four architecturally pleasing panel designs, all with the natural look of deep embossed wood grain and the durability of steel. These doors are polyurethane insulated for maximum energy efficiency. Garage doors made of 40 mm thick steel sections. Sectional doors are with protection from finger press. This door opens vertically and they save additional places in a room. The system of springs, can make from 25 000 to 100 000 take-off and landing cycles.
TYPES OF SEGMENTS
FLUSH (continuous)
MACRORIB (10 mm wavelets)
TOPRIB (bar above)
MICRORIB (5 mm wavelets)
MIDRIB (middle bar)
FILING
RIB (with tapes)
TYPES OF SURFACES
Wood texture
Plaster texture
Smooth
STANDARD COLORS
RAL1015
RAL6009
RAL9004 RAL9005
RAL3000
RAL7016
RAL9006
RAL5010
RAL8017
RAL9007
RAL6005
RAL9002
RAL9016
SEGMENT SURFACES
Light oak
Mahogany
Copper
Golden oak
Vincester wood
3D white
Old oak
Anthracite
3D gray
Dark oak
Stainless Steel
Natural hardwood
Note: The colors (shades) displayed on the page may differ from the actual product (shade).
p
You can choose the colors we offer or the gate will be painted in the color of your choice.
Gate inside surface – White (RAL 9016)
SANDWICH construction used for garage door sections. This construction provides durability and reliable thermal insulation.
1. “Cold brake” separating the outer, cold metal coating from the inner one.
2. Polyurethane thermal insulation layer (R = 2.32).
3. Inter-segment sealing gasket.
4. Segment bindings.
5. Tape (or filing) pattern.
6. Inner strips of continuous steel.
7. Galvanized steel coating with polyester.
• rolled steel sheet;
• the zinc layer is covered by “Sedzimir” deep galvanizing;
• phosphate layer;
• polyester coating.
Airtight seals reliably protect the garage against wind and cold:
1. upper gate seal.
2. lower gate seal.
3. side gate seal with double gasket.
4. inter-segment sealing.
1. “Cold brake” separating the outer, cold metal coating from the inner one.
2. Polyurethane thermal insulation layer (R = 2.32).
3. Inter-segment sealing gasket.
4. Segment bindings.
5. Tape (or filing) pattern.
6. Inner strips of continuous steel.
7. Galvanized steel coating with polyester.
• rolled steel sheet;
• the zinc layer is covered by “Sedzimir” deep galvanizing;
• phosphate layer;
• polyester coating.
Airtight seals reliably protect the garage against wind and cold:
1. upper gate seal.
2. lower gate seal.
3. side gate seal with double gasket.
4. inter-segment sealing.

Pin It on Pinterest